Toribash
Original Post
help w armband
I'm working on an armband, I was convinced I could figure things out and get it mapped correctly but it's trickier than I thought. I didn't plan for it to be seamless so I'm trying to just leave a gap between top and bottom. The thing is there's a seam at every single corner and I'm not sure how to fix them. Any advice?




Last edited by N3WB; Jun 2, 2018 at 02:02 PM.
M8
[SIGPIC][/SIGPIC]


preview

]
remember, each side of the template rectangles are a side of the arm/box
there are the edges, maybeyou plan to not reach the edge in each design, so map accordingly.
thanks for the help dengue,
i think im gonna try that see how it turns out
M8
[SIGPIC][/SIGPIC]